In short
LiftMaster, Chamberlain, Craftsman and Genie openers are all repaired in Old Tappan. Note the brand and model number on the motor unit, then call: most faults are a gear, a board, a capacitor or the sensors, and the price is given before work starts.

Openers we see in Old Tappan
In Old Tappan's newer developments, large homes have three and four bays with tall doors on LiftMaster belt-drive or wall-mount operators, with Wi-Fi and battery backup; the usual faults are in the electronics, after lightning or an outage. In central Old Tappan, ranches, bi-levels and colonials from the 1960s and 70s have Craftsman and Chamberlain chain drives and Genie screw drives from later decades, due for gears, capacitors or retirement. Bi-levels put bedrooms over the garage, and noise is a frequent complaint. On the Lake Tappan side, damp from the reservoir corrodes boards. Wooded northern and eastern streets lose power. With no train in town and few sidewalks, the garage door is the front door for most households. Near the golf club and along Orangeburgh Road, long driveways lead to side-entry garages, where the sensors and the keypad sit out of sight of the house and get forgotten until they fail.
Which opener do you have?
The brand is printed on the motor unit on the ceiling and usually on the remote. Three names cover most garages:
- LiftMaster is sold through dealers and installers. If the opener came with the house or was fitted by a door company, it is often a LiftMaster.
- Chamberlain is the same manufacturer's retail line, sold in home-improvement stores. Many older Craftsman openers were built by the same company and take the same parts.
- Genie is a separate manufacturer with its own remotes, sensors and parts.
Before you call, note the brand and the model number on the label of the motor unit. It saves a step.
Typical problems with LiftMaster, Chamberlain and Genie
- Worn drive gear. The most familiar failure on older chain-drive LiftMaster, Chamberlain and Craftsman units. The motor spins, the door does not move.
- Logic board. Lights flash, the unit clicks, or it works only some of the time. Lightning and power surges are the usual cause.
- Remotes and keypads. A remote from the wrong generation will not pair. The Learn button's color, or Genie's code type, decides which ones work.
- Screw-drive wear. On older Genie openers, a worn carriage lets the door jerk or stop.
- Sensors. Each brand has its own, and they are not interchangeable.
Fixing it, or fitting a new one
Most opener faults are repairable: gears, capacitors, boards, sensors, remotes, chains and belts. The technician brings the common parts for LiftMaster, Chamberlain and Genie units and matches anything else by model number.
An opener that is twenty years old, has already had major repairs, or lacks current safety features may not be worth another part. In that case you are shown what a replacement would involve, including quieter belt-drive units, wall-mount units for low ceilings and models with battery backup, and you decide. The price is given before work starts.
Brand names are used here only to describe the equipment being repaired. HIC and the technicians in its partner network are independent and are not affiliated with, authorized by or endorsed by Chamberlain Group, LiftMaster, Craftsman or Genie.
Around Old Tappan
- Northern streets: Near the New York line, with wooded lots and long drives.
- Eastern streets: Toward Norwood and Harrington Park, with mid-century and newer homes.
See the full Old Tappan service area.