In short
A dented garage door panel in Old Tappan can usually be replaced without changing the whole door. If the door is old and matching panels are no longer made, or several sections are damaged, a new door can cost little more and is worth comparing.
Panel damage in Old Tappan
Old Tappan is almost entirely single-family homes, many of them large, with attached garages and wide insulated doors. When a section on one of those doors is dented, matching its thickness, pattern and color is the key, and older doors from the 1980s and 1990s may be models that are no longer produced. Near Lake Tappan and the Hackensack River on the west side, damp air rots wood doors and rusts steel ones along the bottom edge. Snow pushed against a closed door, cars backing out, and lawn equipment account for most dents in the lowest section. The newer developments have recent doors with matching sections usually still available, though an association may expect an exact match. When a section is replaced, the hinges and rollers on it are renewed and the door is rebalanced. If no match exists, a new door is priced for comparison before anything is ordered.
What can be fixed on its own
Most damage is to the bottom section, which takes the bumps from cars, bikes and the mower, and to the section at bumper height. Either can be swapped individually if a match is available. Cracked or broken window glass and decorative inserts can often be replaced without changing the panel at all. Small dents in steel can sometimes be left alone if the section still runs straight. Rot in a wood door is usually limited to the lowest section at first, and that section can be replaced before it spreads.
Hit by a car?
Backing into a closed garage door is one of the most common causes of panel damage. Even if the door still opens, check that it runs straight and closes evenly. A hard hit can bend the bottom section and the track, loosen the brackets that hold the track to the wall, and knock the door partly off its rollers. Do not keep using a door that grinds or tilts after an impact. If the damage might be covered by your car or home insurance, take photos before anything is moved, and ask for a written description of the repair.
How a panel replacement is done
The technician first identifies the door's make, model, size and color, then orders the matching section. On the day of the repair, the door is secured and the spring tension is released before any hinge or bracket is undone. The damaged section is taken out, the new one is fitted with its hinges and rollers, and the door is reassembled. Because a new section can weigh a little more or less than the old one, the springs are rebalanced afterwards, and the opener's travel and safety reverse are tested.
Around Old Tappan
- Lake Tappan side: Homes near the reservoir on the western edge, where damp affects hardware.
- Central Old Tappan: Around Old Tappan Road and the schools, with colonials and attached garages.
See the full Old Tappan service area.