Garage door won't close: sensor repair in Old Tappan

A garage door that refuses to close is annoying, but it is the safety system doing its job.

Call (551) 250-4208

In short

If the garage door starts to close and comes back up, or the opener light blinks, the safety sensors near the floor are usually misaligned, dirty or have a damaged wire. Wipe the lenses and check both lights are steady; if it still won't close, a technician in Old Tappan realigns or replaces the sensors and tests the safety reverse.

Belt-drive garage door opener on the ceiling rail

Doors that won't close in Old Tappan

On the Lake Tappan side of Old Tappan, the reservoir and the Hackensack River keep the air damp, and morning fog leaves sensor lenses wet in spring and fall. In central Old Tappan, mid-century houses have two-car attached garages with original brackets. On the northern streets near the New York line and on the eastern streets, lots are wooded, and leaves and mice are the usual suspects. The newer developments have large homes with three or four bays, and the door used least is the one with cobwebs across its beam. Landscape crews blowing mulch and clippings into open garages are a weekly cause.

What it means when the door won't go down

Every opener made since 1993 has two photo-eyes a few inches above the floor, one on each side of the door. If the beam between them is broken, or the opener cannot tell whether it is, the door will not close from the remote.

  • Blinking sensor light: the eyes are out of line or one lens is dirty.
  • Both lights off: no power to the sensors, usually a wire pulled loose or chewed.
  • Lights steady but the door still reverses: the problem is the close limit, the force setting, or something binding in the track.

Quick things to rule out

  • Is anything in the path of the beam, even a leaf or a cobweb?
  • Are both sensor lights lit and steady?
  • Does the problem only happen at one time of day? That points to sun in the sensor.
  • Is the wall control's lock or vacation button switched on? It disables the remotes.

Anything beyond that, including limit and force adjustment, is a job for a technician, because a wrong setting can stop the door from reversing when it should.

How the repair is done

The technician tests the sensors and their wiring, realigns or replaces them, then checks the close limit and the force setting. Before leaving, the door is tested on a block of wood laid flat in the doorway: it has to reverse as soon as it touches it. If the door itself is binding in the tracks, that is corrected too, since a stiff door is often what set the opener off in the first place.

Around Old Tappan

  • Eastern streets: Toward Norwood and Harrington Park, with mid-century and newer homes.
  • Newer developments: Recent subdivisions and townhomes with attached garages.

See the full Old Tappan service area.

Door stuck? Call before you try to force it.

Keep people and pets away from a door that's stuck or crooked, unplug the opener, and give us a call.

Call (551) 250-4208
Call (551) 250-4208